Akai CD3000XL Betreibershandbuch PDF herunterladen (Seite 72)

EDIT PROGRAM - SINGLE

Page 66 S3000XL Operator’s Manual

OUTPUT LEVELS PAGE

Pressing the button takes you to the OUTPUT LEVELS page where you can control

the audio output of the program from the S3000XL. You will receive this screen display:

At the top right of the screen is the currently selected program name - in EDIT SINGLE,

this may be changed and another selected for editing by scrolling with the DATA control.

The parameters on the left of the screen set parameters concerned with output routing

and levels, etc.. They are as follows:

This sets the level 0-99 of the program as it appears at the L/R

stereo outputs. Adjusting this has no effect on the level of the

signal appearing at the individual outputs or the real-time digital

outputs.

By setting this field to 00, you may use this parameter to mix a

program out of the L/R mix completely if you are sending it to an

individual output (see above). In this way, you may have some

programs appearing only at the L/R outputs with other programs

appearing only at the individual outputs.

This sets the overall pan position of the program. You can set the

parameter L50-MID-R50. You will note that this may be affected

by other pan settings elsewhere in the program such as when the

auto pan facilities are used or when individual keygroups are

panned.

You will note that this parameter also affects the level of the signal

appearing at the individual outputs (see below) and at the real-

time digital audio output.

This allows you to select which of the 8 individual outputs the

whole program will appear at. The default is OFF and you may

select 1-8. You will note that these outputs are polyphonic and can

use the full 32-voice polyphony of the S3000XL.

NOTE: This parameter works in conjunction with a field found in SMP2 (see below) where

it is possible to route single keygroups to the individual outputs

This sets the level 0-99 of the signal appearing at the output

selected above. If OFF is selected, then this control has no effect.

This sets the FX channel the program is routed to. You may select

OFF, FX1, FX2, RV3, RV4

This sets the effects send level 0-99 going to the selected effects

channel

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 312 313

Keine Kommentare

Akai CD3000XL Betreibershandbuch Seite 72