Akai CD3000XL Betreibershandbuch PDF herunterladen (Seite 136)

EDIT SAMPLE

Page 130 S3000XL Operator’s Manual

Moving the cursor to the field and adjusting that will give you a display such as:

As with the field, you may move the cursor around the numeric field using the +/<

and -/> keys found on the numeric keypad. Running across the top of the waveform

display you will see up to four horizontal lines which show you where you have set your

loop point(s). Up to four may be shown simultaneously - the top one is LOOP 1, the

second one down is LOOP 2, the next one down LOOP3 and the bottom one is LOOP 4.

I.e:

LOOP1 LOOP2 LOOP3 LOOP4

The loop points cannot be edited in the TRIM page but these will give you a clearer

indication of where you are when setting start and end points for trimming. If you move

the start or end points into a loop, you will see this screen:

A similar screen would be shown if you were to move the end point into a loop. The

warning will be shown temporarily and you should move the start (or end) point out of the

loop.

Once you have set the start and end points, press F8 - - to discard the unwanted

audio either side of the start and end point. You will receive this screen display:

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 312 313

Keine Kommentare

Akai CD3000XL Betreibershandbuch Seite 136