Akai CD3000XL Betreibershandbuch PDF herunterladen (Seite 124)

SAMPLE

Page 118 S3000XL Operator’s Manual

RECORD MODE

Pressing SAMPLE enters the record or ‘sampling’ mode. The first screen you see is the

RECORD SETUP page where you may set certain parameters related to recording.

This shows that you have named (or selected for over-writing) a sample called STRING

C4. You may select another sample for recording over if you wish (assuming they exist, of

course!) by moving the cursor to the sample name field and scrolling through the available

samples. You may also rename or copy the sample in the usual way by pressing NAME -

you will receive this prompt:

The first character of the name will be highlighted. Use the front panel keys to enter a

suitable name of up to 12 characters. Press NAME again to use the numeric keypad to

enter numbers.

As soon as you create a new, unique name, you will see * NEW * displayed under the

sample name:

Finally, to finish naming, press ENT/PLAY.

The fields on this page are:

Here you may select between stereo or mono recording. If you select

STEREO, the sample will automatically have -L and -R appended to both

the left and right samples respectively after the recording has been made.

After that, any editing you do will be done in stereo unless you specifically

switch back to mono.

To the right of this parameter is another (shown LEFT in the above

example). This allows you to select which of the channels will initiate the

recording when STEREO is selected and you are using INPUT LEVEL to

start recording (see below - . When MONO is selected, this field

defaults to LEFT but, when STEREO is selected you may set which input

channel you want to trigger recording.

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 312 313

Keine Kommentare

Akai CD3000XL Betreibershandbuch Seite 124