Akai CD3000XL Betreibershandbuch PDF herunterladen (Seite 294)

APPENDIX 4

Page 288 S3000XL Operator’s Manual

SAVING DATA TO THE FLASHROM

Saving data to FlashROM is virtually identical to saving data to disk and is done,

surprisingly enough, in the SAVE mode. Pressing SAVE will show something like this

screen:

As well as the usual FLOPPY or HARD-: options normally available at the top centre of the

screen, you may also choose FLASH thus:

As with a hard disk, the FlashROM is divided into ‘volumes’ and there are 100 volumes

you can use, selected in the VOL: field to the right of the FLASH selection. Each volume

can hold as much data as you like. For example, you could have lots of volumes with

small amounts of data in each volume or you could save a full 8Mbytes to just one

volume. There are different types of FlashROM volumes you should be aware of. These

are:

BOOT SYSTEM In this, the first FlashROM volume, you may save an

operating system and this will boot up automatically when

you switch on the S3000XL/S3200XL. This has the

tremendous advantage that if you receive a software

upgrade in the future, it may be saved to FlashROM and

the new operating system will boot from this without you

having to obtain a new ROM chip or needing to have the

floppy disk to hand when you want to use the sampler.

When any subsequent software upgrades are released,

you will receive these on floppy disk and these may be

saved to the BOOT SYSTEM volume. In fact, you can

save your new operating system to the FlashROM.

To save the operating system, select FLASH and move

the cursor to the VOL: field and use the DATA wheel to

select BOOT SYSTEM. Now select OPERATING SYSTEM

as the TYPE OF SAVE:

1 2 ... 289 290 291 292 293 294 295 296 297 298 299 ... 312 313

Keine Kommentare

Akai CD3000XL Betreibershandbuch Seite 294