Akai RE32 Betreibershandbuch PDF herunterladen (Seite 47)

Version 1.00 37

RECORDING

ADVANCED RECORDING

There is no ‘advanced recording’ mode as such - this section just tells you more about the recording

functions.

Recording is designed to be as simple as possible and you may, if you wish, make a recording as

described above. However, it is also possible to name recordings although recordings are given a

default name so that you may avoid this process if you just want to get on with the job and the

recording can be renamed afterwards. There are other parameters associated with recording which

can set if you wish.

When you switch off the ALL SAFE key, you will see this screen:

The fields on this screen are:

RECORDING NAME Here, you may name the recording you are about to make by typing a

suitable name of up to ten characters on a PS/2 keyboard connected to

the RE32. Press RETURN to complete the naming process.

NOTE: The Akai DD/DR-Series of disk recorders have an ‘auto-increment’ function for names

and so each new recording you make will have a new name based on the ‘seed’ name you

give it here. For example, if you name a recording GUITAR, all subsequent recordings you

make will be automatically named GUITAR 1, GUITAR 2, etc., until you specify a new ‘seed’

name in this field

The autoname function does not work when performing a punch-out followed by a punch-in. In

this case, both recordings will have the same name. This is not a problem because recordings

can have the same name in a project. Recordings can be renamed afterwards if you wish.

RECORD MODE In this field, you may select how the recordings you are about to make

are stored in the project.

The default setting is PROJECT ONLY. With this selection, new

recordings will be placed only into the currently active project. This

selection is non-destructive - each time a new recording is made, existing

files on disk from previous recordings will be unaffected.

You may also select DESTRUCTIVE. This is a special type of record

mode that behaves more like traditional tape.

As mentioned, recording is non-destructive by default but, sometimes

when recording, it is possible to build up a lot of redundant audio on your

disk, especially if you are dropping in and out over the same point time

and time again (for example, when recording vocals). As a result, your

disk can soon become full of audio you cannot access or use. The

DESTRUCTIVE record mode goes some way to overcome this.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 191 192

Keine Kommentare

Akai RE32 Betreibershandbuch Seite 47