Akai RE32 Betreibershandbuch PDF herunterladen (Seite 152)

142 Version 1.00

SYSTEM SETUP

SETUP - MULTI

When MULTI mode is selected, pressing the SETUP key will display the following options:

The MULTI SETUP pages are designed to allow easy configuration of parameters that should be

set identically on each machine connected to the system.

Pressing RATES (F1) will take you to the SYSTEM RATES page:

This page is used to set the system’s global sample rate and frame rate.

The parameters are:

SAMPLE RATE This sets the system’s sample rate. You may select 32kHz, 44.056kHz,

44.1kHz and 48kHz. Other options may be available depending on the

facilities available on the connected machines.

On entry to this page, if all connected machines are set to the same

sample rate, then this rate will be displayed. If not, the sample rate field

will say “* DO NOT MATCH *” until a new rate is selected.

NOTE 1: This page will only allow selection of sample rates that are supported on all the

connected machines.

NOTE 2: Recordings made at a sample rate other than the selected sample rate will play back

at the wrong speed. For example, if the sample rate is set to 44.1kHz and you try to play back

a recording made at 48kHz, the recording will play back slow. Therefore, please make sure

that your recordings are made at the correct sampling rate. Recordings made at different

sample rates cannot be used in the same project.

TC FRAME RATE This shows the system’s timecode rate.

This field is not editable, but instead serves as a visual check that all

machines are configured correctly. If all machines are set to the same

frame rate, then this rate will be displayed here. If not, this field will say

“* DO NOT MATCH *”.

Timecode frame rates can be individually set on each machine as

explained later in the section on TIMECODE SETUP.

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 191 192

Keine Kommentare

Akai RE32 Betreibershandbuch Seite 152