Akai DR16 pro Betreibershandbuch PDF herunterladen (Seite 97)

11: Editing

Page 88

Executing the Copy

1) Press the STORE/ENT key to execute the copy.

When the DR16pro has completed the copy operation, the message “DONE” will momen-

tarily appear on the display.

The LED beside the EDIT key will switch off and the previous mode restored.

Copy+Insert

The copy+insert function works basically the same as the copy function. However, unlike copy, the

copy+insert function moves any existing material at the specified destination behind the new ma-

terial rather than overwriting it. The following diagram illustrates the copy+insert procedure:

Destination insert point

"in" point "out" point

Destination insert point

Source Track

Destination Track

Source and Destination Track

TIME

Section

Section Copy

Copy

The following steps are similar to the operation detailed in “Copy” on page 86. Only an outline is

provided here. Refer to the previous steps for explanations.

1) Set the “in” and “out” points to define the copy source section.

See “Specifying the “in” Point and “out” Point” on page 26.

2) Locate to the desired position for the destination insert point.

Refer to the “Locate Functions” on page 77.

3) Press the EDIT key to enter Edit Mode.

The EDIT indicator will light up

4) Use the JOG/SHUTTLE control to select the Copy+Insert function.

You will see a display similar to the following:

ABS

EDIT

5) Press the STORE/ENT key.

6) Use the JOG/SHUTTLE control to specify the number of repeats.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 166 167

Keine Kommentare

Akai DR16 pro Betreibershandbuch Seite 97