Akai S5000 Bedienungsanleitung PDF herunterladen (Seite 8)

Step 4 – Connecting the SCSI/IDE Board and Card Reader for Power

A 4-pin Molex Power Y-Adapter is needed to ‘bridge’ the card reader,

scsi/ide board for power. And a custom 4-pin molex power adapter is

needed to connect Y-Adapter to the AKAI S6000 power source (4 pins).

Pay careful attention to the molex connector as the

red wire is on the

left side and provides 5V to the scsi/ide board and card reader. The

yellow wire

is meant for 12V and if connected the wrong way, it will

damage the drive. Plug connector exactly as shown in picture. So

proceed carefully and at your risk. So, red wire on the left and yellow

wire on the right, and everything will be good to go.

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

Akai S5000 Bedienungsanleitung Seite 8