Akai MPC2500 Bedienungsanleitung PDF herunterladen (Seite 12)

08. Press “Play” on the CD Player.

The MPC2500 will start the recording automatically when the CD player starts the playback and the

bottom of the screen will change as below:

Tip : If the recording level is too low, the MPC2500 may not start the recording when you play the

CD player. In this case, go back to step 5 and adjust the level with the [ REC GAIN ] knob again.

09. Press the [ F6 ] (STOP) button to stop the recording.

If you do not press [ F6 ] (STOP), the MPC2500 will stop the recording at the time set in the Time

field.

When the MPC2500 finishes the recording, the Keep or Retry window will be displayed.

10. You can check the recorded sample by pressing and holding the [ F4 ] (PLAY) button.

The recorded sample will play until you release the button.

If you do not like the recording, you can remove the recording by pressing the [ F2 ] (RETRY)

button.

 Assigning the recorded sound to the pad

11. Select the Assign to pad field with the cursor and hit the pad to which you wish to assign the

sample.

The number of this pad will be displayed in the Assign to pad field.

12. Press the [ F5 ] (KEEP) button to save the sample to the selected pad.

This closes the Keep or Retry window and returns to the RECORD page.

Now you can play the recorded sample with the pad. Hit the pad to make sure the recorded sound

will be played.

Tip : The samples will be assigned to the pads of the program that is selected in the Pgm field of the

MAIN page. To assign the samples to a new program, you need to create a new program in

PROGRAM mode and select it in the Pgm field of the MAIN page in advance. For more information

about creating a new program, see the “Creating a program” section of the Operator's Manual.

(page 78)

Tip : You can play back only a specific part of the sample by adjusting the start/end points. For

more information, see the “Setting the loop” section of the Operator's Manual. (page 76)

Tip : You can change the assigned sample or set the playback method in the PROGRAM mode. For

more information, see the “Chapter13 : Program” section of the Operator's Manual. (page 78)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 73 74

Keine Kommentare

Akai MPC2500 Bedienungsanleitung Seite 12