Akai S950 Bedienungsanleitung PDF herunterladen (Seite 3)

Power-On Sequence

Step 1:

Be sure both machines are turned off.

Step 2:

Turn ON the hard disk unit first, then turn ON the S950.

This sequence must be followed at all times. Otherwise, the S950 will not

recognize that the hard disk unit is connected. (When the S950 is turned on,

the IB-109 SCSI ID will be set at "0" (the default value).

If you are using one hard disk unit, set the ID to "0". The "Hdrive" default value

(logical unit number) should be "1". You will not have to reset them later.)

Step 3:

Enter PAGE01 in DISK mode.

Step 4:

Specify a "SCSI #" value using the CONTROL knob.

+--------------------------------------+

|>01 VOLUME *Slct,create Floppy S900|

|*SCSI #0 *Hdrive1 *Rename Floppy XXX%|

+--------------------------------------+

Note:

If you are using several SCSI hard disk units, setting them to individual ID

numbers (0-7) and logic unit numbers (1-8) will allow up to 64 (8x8) SCSI hard

disk units to be connected to the S950 (via the IB-109) in a daisy chain.

Format and Wipe

Entering DISK mode

Step 1:

Insert a 2DD/2HD floppy disk into the S950 disk drive. Press the DISK key to

enter the DISK mode.

When you press the DISK key without either of the above floppy disks inserted

into the S950 drive, the S950 will display "OOPS! Disk not mounted".

Insert the floppy disk and press the DISK key again.

Step 2:

Go to PAGE09 in the DISK mode using PAGE UP key. You can now format or

wipe (initialize) a hard disk (if a cartridge disk is in the hard disk unit).

1 2 3 4 5 6 7 8 9

Keine Kommentare

Akai S950 Bedienungsanleitung Seite 3