Akai MPC Betreibershandbuch PDF herunterladen (Seite 73)

Section 3: Recording sequences

3.14 The recording metronome

Whenever RECORD or OVERDUB mode is entered, a click sound is heard

through the stereo mix outputs on every U4 note, with a louder click at the

start of each bar. This is the recording metronome. There are two

metronome adjustments, both of which are accessed by pressing the

OTHER key, which displays the following screen:

The three metronome adjustments are:

• The METRONOME field:

This field controls the volume of the metronome, both to the stereo mix

and the to the metronome output jack. The range is 0 (off) to 14 (full

volume).

• The RATE field:

This field controls the note value of the metronome. Normally, the

metronome plays 1/4 notes. In this field it is possible to change that

value to one of eight options:

1/4 notes 1/4 triplets 1/8 notes 1/8 triplets

1/16 notes 1/16 triplets 1/32 notes 1/32 triplets

• The IN PLAY field:

This is a choice field which has two options:

1. "NO": The metronome is only heard during RECORD or

OVERDUB modes, but not while in PLAY mode.

2. "YES": The metronone is heard in PLAY, as well as in

RECORD and OVERDUB modes.

The rear panel metronome output jack

The output of the metronome is routed to its own individual jack on the

rear panel, the METRO OUT jack. The output level at this jack is also

controlled by the metronome VOLUME field, above. If a plug is inserted

into this jack, the metronome will no longer be heard in the stereo mix.

When the plug is removed, the metronome will once again be heard in the

mix.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 227 228

Keine Kommentare

Akai MPC Betreibershandbuch Seite 73